TV Setup, Conﬁguration | Technika LCD32-209V

Some Digital Terrestrial channels operate on a Pay Per View basis. These require a subscription and a hardware decoder.

Obtain the Conditional Access Module (CAM) and the viewing card by subscribing to a pay channel company, then insert those to the TV using the following procedure.

•Switch off the TV and unplug from the mains.

•Insert the CAM and then the viewing card to the slot that is located in the terminal cover at the left-hand side of the TV (from front view).

•The CAM should be correctly inserted, it is impossible to insert fully if reversed. The CAM or the TV terminal may be damaged if the CAM is forcefully inserted.

•Connect the TV to the mains supply, switch on and then wait for few moments until the card is activated.

•Some CAMs may require the following set up. Please set the CAM by entering the IDTV menu, Conditional Access then pressing the OK button. (CAM set up menu is not displayed when it is not required.)

•To see the viewing contract information: enter IDTV; press the “MENU” button, then highlight Conditional Access and press the OK button.

•When no module is inserted, “No Conditional Access module detected” message appears on the screen.

•Refer to the module instruction manual for details of the settings.

NOTE: Insert or remove the CI module only when the TV is switched off or in standby mode.

TV Setup

You can use this item to display the TV functions.

The digital TV Setup menu screen is accessed from the main menu. Press the “MENU” button to display the main menu and use “” or “” button to highlight “TV Setup”, press the OK button to display TV Setup menu screen.

You can ﬁnd detailed information for all menu items in “Analogue TV Menu System” section.

Setup

The adjustments in this menu are given as the following:

Conﬁguration

You can conﬁgure the settings of your TV. Select Conﬁguration from Setup menu and press OK to view this menu. Press the EXIT button on the remote control to exit.