NOTE
DO NOT operate an electric starter for more than 5 seconds each attempt.
5.Push starter button or turn ignition switch key to start engine.
6.When engine starts, release starter button or ignition switch key.
7.If engine fails to start after 3 attempts repeat steps 2 thru 6 and try again.
8.If engine does NOT start after following steps 1 thru 7, contact your Authorized TecumsehPower Servicing Dealer. DO NOT attempt to start or troubleshoot this engine in any other way.
II. Choke Only
1.To avoid carbon monoxide poisoning, be sure engine is outdoors in a
2.Move engine throttle control to “CHOKE” or “START” position, if present (see equipment manufacturer’s instructions). See Figures 12, 13 and 16 starting on page 7. Afterward, continue reading instructions below.
NOTE
If restarting a warm engine after a short shutdown, move engine throttle control to “FAST” position instead of “CHOKE” or “START” position. See Figures 12, 13 and 16 starting on page 7. Afterward, continue reading instructions below.
3.Operate equipment control to release engine brake or clutch, if present (see equipment manufacturer’s instructions). See Figure 12 on page 7. Afterward, continue reading instructions below.
NOTE
DO NOT operate an electric starter for more than 5 seconds each attempt.
4.Push starter button or turn ignition switch key to start engine.
5.If engine fails to start after 3 attempts repeat steps 2 thru 4 and try again.
6.When engine starts:
a.Release starter button or ignition switch key.
b.Move engine throttle control to “FAST” position.
c.Next, move engine throttle control to desired speed in “RUN” range.
NOTES
If engine starts but falters when engine throttle control is moved to “FAST” position:
a.Move engine throttle control back to “CHOKE” position.
b.Next, move engine throttle control to “FAST ”position.
If engine dies after engine throttle control is moved to “FAST” position, repeat steps 2 thru 6 to restart engine.
|
|
|
| 3 |
|
2 |
|
|
|
|
|
| 1 | 7 | 6 | 5 | 4 |
1. | Spark Plug Cap |
|
|
|
|
2. | Spark Plug Wire |
|
|
|
|
3. | Starter Cord Handle |
|
|
|
|
4. | Air Cleaner |
|
|
|
|
5. | Primer Bulb |
|
|
|
|
6. | Carburetor |
|
|
|
|
7. | Muffler |
|
|
|
|
Figure 15. Engine Components
3
2
1
1.“SLOW” Position
2.“RUN” Range
3.“FAST” Position
Figure 16. Start/Choke Control Positions
7.If engine fires but does NOT continue to run, move engine throttle control to “FAST” position and start engine.
8.If engine fails to start after 3 attempts in the “FAST” position, move engine throttle control to “CHOKE” position and start engine.
9.If engine does NOT start after following steps 1 thru 8, contact your Authorized TecumsehPower Servicing Dealer. DO NOT attempt to start or troubleshoot this engine in any other way.
Page 8 |
