Tefal IS6300T1 manual Troubleshooting

TROUBLESHOOTING

Problems	Possible causes	Solutions
There is no steam.	The appliance has not been turned	Check that the appliance has been
	on.	plugged in correctly. Next press the
		On/Off pedal, the power indicator light
		located at the front of the appliance will
		come on.
	The hose has been obstructed.	Check that the hose is not bent or twisted.
		The device will begin producing steam
		after approximately 60 seconds.
	There is no water left in the water	Switch off the appliance and fill the water
	tank.	tank.
/ ÊÃÌ “ÊyœÜʈÃʏœÜ°	Your steamer has a build-up of scale	See descaling process (Cleaning
	because it has not been rinsed out	paragraph).
	regularly.
	The hose has been obstructed.	Check that the hose is not bent or twisted.
	There is no water left in the water	Switch off the appliance and fill the water
	tank.	tank.
	The steam is not ready yet.	The appliance will produce steam about
		60 seconds after it has been switched on.
Water runs through	There is condensation in the hose.	Never use a steamer in the horizontal
the holes of the steam		position. Hold the hose vertically
head.		outstretched and wait for the condensed
		water to return to the steamer.
The steamer takes	Your steamer has a build-up of scale	See descaling process
a long time to heat	because it has not been descaled	(Cleaning paragraph).
and/or ejects white	regularly.
particles.
The Roll & Press	The panel didn’t roll back correctly.	Unroll the panel again and keep your
system panel is		hand on the handle while rolling back to
crooked.		the top.
The Roll & Press	The panel didn’t roll back correctly.	Make sure the Roll & Press handle is
system panel rolled		firmly locked in the hook. It should not be
back up while in use.		moving horizontally or vertically.
The hose makes a	You are using the steam head in a	Raise the hose frequently during use and
gurgling noise.	position close to the ground and	adjust the pole to its maximum height in
	some condensation occurs in the	order to avoid
	hose.	the formation of condensation.
7 Ì ÀʈÃʜ ÀyœÜˆ˜}Ê	You are using the steam head in a	Raise the hose frequently during
from water tank.	position close to the ground and	use and adjust the pole to its
	some condensation occurs in the	maximum height in order to avoid
	hose.	the formation of condensation.

If you have any further problems or queries please contact the TEFAL Customer Relations Helpline - see ` Ì ˆÃÊ ÌÊ̅ Ê ˜`ʜvÊ̅ˆÃʏ y Ì°

10

1800129542 IS6300T1.INDD 10 24/05/13 09:09