purchased, have it checked by an Approved Service Centre.
-Remove all packaging materials, stickers and accessories from inside and outside of the appliance.
-Unwind the power cord fully before use and inspect the appliance and power cord for signs of wear or damage prior to connecting to the power supply.
-Any intervention other than normal cleaning and maintenance by the customer must be performed by an Approved Service Centre.
-Do not cut or attempt to extend the steaming hose.
-To prevent the appliance over heating, when you hang the clothes on the garment hook for removing creases, please assemble the attached garment telescopic handle and extend it to its highest position.
-The glove should be only used with this garment steamer. The manufacturer accepts no responsibility for any inappropriate use
Environmental protection first!
Your appliance contains valuable materials which can be recovered or recycled.
When disposing of it, take it to a local civic waste collection point.
DESCRIPTION
1. | Steam head | 14. | Velcro strip |
2. | Steam head hook | 15. | Pole fastening screw |
3. | Built in hanger | 16. | Steam hose connector |
4. | Rotary trouser/dress clips | 17. | Removable water tank |
5. | Hanger holder | 18. | ON/OFF pedal |
6. | Roll & press system: vertical support | 19. | Transport wheels |
| panel | 20. | Textile steam hose |
7. | Roll & press system: rolling and | 21. | On/ off light |
| locking handle | 22. | Built in accessories* |
8. | Roll & press system: locking hook |
| A. Fabric brush |
9. | Hanger fastening screw |
| B. Lint pad |
10. | Pole locking clips |
| C. Delicates steam cap |
11. | Telescopic pole |
| D Glove |
12. | Electric cord holder |
| E Crease attatchement |
13.Electric cord
BEFORE USE
ÊUÊ À ÌÊÃÌ ÀÊ ÃÃ LÞ
Pole assembly
1.Unscrew the fastening screw on the base of the pole (fig. 1).
2.Hold the pole such that the cord holder is on the left. Check that the 2 pole clips are unlocked (fig. 2).
3.Insert the pole into the base by pressing downwards until the holes of the pole and base are at the same level, so that you can put the screw back. If the holes are not aligned, check that the clips of the pole are well and truly unlocked (fig. 3).
4.Screw the pole fastening screw back in as far as it will go so that the pole is firmly fixed to the base (fig. 4).
5.Adjust the pole to its maximum height by sliding it upwards (fig. 5) then locking the 2 clips (fig. 6). Make sure the 3 segments of the pole are fully extended.
* Depending on model | 4 |
H
1
2
3
4
5
U
U
U
U
U
U U U
U
T
U
1800129542 IS6300T1.INDD 4 | 24/05/13 09:09 |
