Tefal ZC500H66, ZN655H66, ZP600033 What to do if Your Appliance does not Work, Problems Solutions

Make sure to clean the inside of the screw (C) carefully; if necessary, use the brush (P). Clean the residue exit (K) with a lightly moist and non-abrasive sponge.

The pusher (A), the feed tube (B), the bowl (G), the screw (C), the juice collector (H) with the spout with drip-stop (I), the jugs (N), and the foam separator (O) can all go into the dishwasher. If the filters (D/E) are clogged, prewash them with warm water and washing up liquid and use the brush (P). If the filter residue exit is clogged, remove the residues using the other end of the brush (P).

Do not clean the juice collector (H), the spout with drip-stop (I), the plastic parts (bowl (G), food presser (A), feed tube (B)) with the abrasive side of the sponge.

Tips: To extract the screw (C) from the filter (D/E), turn both pieces together and then press on the screw.

WHAT TO DO IF YOUR APPLIANCE DOES NOT WORK

PROBLEMS	SOLUTIONS
The appliance does not turn	- Make sure that all parts are correctly assembled.
on	- Make sure that your appliance is properly plugged in.
	- Check that the feed tube (B) is correctly locked in
	position.
The appliance stops suddenly	- Press the Start/Stop button (M) to switch off the
while functioning: the red	appliance.
light flashes	- Start your appliance again. If the safety mechanism
	shuts the appliance off again, take it apart, clean it and
	turn it on again.
	- Make sure that the screw (C) is not blocked.
The appliance turns off: the	- This is a safety mechanism. We recommend that you let
white light flashes	the appliance cool down for a few minutes, clean it, and
	then restart it by pressing the Start/Stop button (M).
Poor Juice Extraction	- Clean the appliance: wash, rinse out and dry: the feed
	tube (B), the pressing screw (C), the filter (D or E),
	the residue strap (F), the bowl (G), the jugs, the spout
	(H and I) and the dry residue colector (Q).
	- Make sure that the strap (F) is correctly positioned on
	the filter (to collect residues) and that it is in good
	condition.
Problems related to leaking	- Check that all parts are correctly assembled, especially
	the spout with drip-stop (I).

46