Installation Requirements |
| |
In order to operate the automatic ice |
| |
maker/dispenser and chilled water dispenser, |
| |
your appliance needs to be plumbed into the |
| |
cold mains water supply in your house via a |
| |
standard 1/2 “ valve fitting. In case this valve |
| |
is not present or in case you are not sure, | 1 | |
consult a qualified plumber. | ||
2 | ||
| ||
* First of all, make sure that the parts on the |
| |
side are shipped with the device. |
| |
1. |
| |
diameter) |
| |
2. Cold mains water valve with mesh filter |
| |
(Tap Adapter) | 3 | |
3. 3 pieces of pipe clips (In case required to | ||
| ||
secure the water pipe) |
| |
4. Water Filter to be fitted to the bracket | 5 | |
inside the fridge compartment. | 4 | |
5. Nut for connection of the water pipe to the |
| |
rear of the appliance |
| |
Connection to the Cold Mains |
| |
Please follow the instructions below. |
| |
MAKE SURE THAT STANDARD 1/2” | Water Tube | |
VALVE FITTING FED BY COLD MAINS | ||
| ||
WATER SUPPLY IS AVAILABLE AND |
| |
IS TURNED OFF FULLY. |
| |
Connection of the Water Pipe to the |
| |
Refrigerator | Water Tube | |
1. After assembling the nut on the water | Nut | |
| ||
pipe, insert the water pipe to the refrigerator |
| |
inlet valve by pressing downwards firmly. |
| |
2. Fix nut as seen in the opposite figure, by | 2 | |
squeezing by hand on the refrigerator inlet | ||
| ||
valve. | 1 | |
Note: You should not need to tighten the |
| |
nut with a tool to achieve water tight |
| |
assembly. In case of a leak use a spanner |
| |
or a pair of pliers to tighten the nut. | Valve | |
| ||
10 | EN |
