Teka NF1650 manual Cleaning the Icebox and the Water Dispenser, Lift, Pull

cubes and a decrease in the form of ice is normal in case ice is not obtained from dispenser for a long time or in case of power outages. If this is the case, the ice in the icebox must be controlled and the icebox should be emptied and cleaned thoroughly.

Warnings

•No ice must be added to the ice dispenser compartment. This may adversely affect the ice supply or crushing the ice.

•It is normal to have a couple of ice cubes stuck together in the icebank.

•Moving parts such as blades in a housing at the ice outlet of the dispenser must not be touched to avoid injury.

•Never use sharp objects to break the ice in the icebox. This may cause damage on the icebox.

•Food stuff should never be placed into the icebank for quick cooling purposes.

•In case you see condensation on the dispenser (water drops) or in case you connect your device to the water mains, make sure that the anti-condensation switch is pressed. (See Page 15) Anti-Condensation button is pressed as a factory setting.

•When the ice container is to be removed for any reason, first of all Ice Off Button must be pressed.

Ice Off

To stop ice formation, “Ice Off” button is pressed. When ice off is selected, no water will be taken into the Icematic. However, already existing ice can be taken from the dispenser. To restart ice formation, “ice off” button must be pressed again.

Caution: If you do not use the ice dispenser, do not forget to put ice duct cover into the ring inside of the freezer door. (See. Page 2)

Cleaning the Icebox and the Water Dispenser

Follow the procedure and warnings below to clean the icebox:

•Remove the Icebox by lifting first and then pulling towards yourself as shown in the diagram.

•Empty the ice in the Icebox if any. To take out the stuck ice, use objects that are not sharp to avoid any damage on the Icebox.

•Pay attention that the inside of the Icebox is not wet/damp before placing it back to its housing.

•If you want to get ice from the ice dispenser after placing theicebox back to its housing and closing the freezer door, exit from ice off mode by pressing the ice off button again.

•Do not touch moving parts like the knife in the Icebox

19

1. Lift

2. Pull

EN