for 2 seconds and the warning will be reactivated.

Caution: Water filter is for cleaning some foreign particles in the water. It does not purify water from microorganisms.

Caution: Ice off button must always be pressed during replacement of the water filter or installing the bypass cover.

REMOVE

Water Reservoir

 

If you wish to disassemble the water reservoir

 

from the refrigerator for cleaning the vicinity

 

of the water reservoir follow the instructions

 

below;

 

• Remove the 2 screws by using a cross

 

headed screwdriver as shown in the figure.

 

• Gently hold and remove the water reservoir

 

as shown in the figure.

 

Caution:

 

Never remove the bolts, assembled to the

 

water reservoir.

Water Reservoir

 

Ice/Water Dispenser Prior to First Use

 

• Water mains pressure must not be below 1

• In case you see condensation on the

bar.

dispenser (water drops) or in case you connect

your device to the water mains, make sure

 

Water mains pressure must not be over 8 bars.

Pumps must be used in case the water

mains pressure drops below 1 bar.

Water system of the refrigerator must be connected to the cold water line. It must not be connected to hot water line.

Do not forget to remove the ice channel cover from its location before using Ice Dispenser.

that the anti-condensation switch is pressed. (See Page 15) Anti-Condensation button is pressed as a factory setting.

Dispenser will not work when the door of the freezer compartment is open. Make sure that the door is closed for the operation of the dispenser.

No water may be obtained in the initial operation of the refrigerator. This is caused by the air in the system. To discharge air from the system, press Dispenser latch for periods

13

EN

Page 14
Image 14
Teka NF1650 Water Reservoir, Ice/Water Dispenser Prior to First Use, For 2 seconds and the warning will be reactivated