Connection of the Water Pipe to the Cold Water Mains Line
1.Separate the nut from the tap adaptor.
(Figure A)
2.As shown in the figure, assemble the tap adaptor to 1/2” valve fitting (Figure B)
3.As shown in the figure, after inserting the water pipe to the nut, install it to the tap adaptor and insert to the tap as shown in the figure. (Figure C)
4.Tighten the nut manually. In case of a leak use a spanner or a pair of pliers to tighten the nut.
Caution: Secure the water pipe to suitable points by means of the pipe clips supplied to avoid any damage or displacement or accidental disconnection.
Caution: After turning on the water valve, make sure that there is no leakage at both connection points of the water pipe. In case of a leak, turn off the valve immediately and tighten all joints again using a spanner or a pair of pliers.
Mesh Filter | Main Cold Water Line |
|
Tap
Adaptor
Feed
Valve
Nut
Tap Adaptor
Figure A | Figure B |
|
Tap
Adaptor
Nut
Water Tube
Figure C
11
EN
