Teledyne manual Appendix C Warranty/Repair Questionnaire, M265E and T265

Appendix C

Warranty/Repair Questionnaire

M265E and T265

(P/N 074990000 Rev A, DCN# 6167)

CUSTOMER: ____________________________________ PHONE: ___________________________________________

CONTACT NAME: _______________________________ FAX NO. ___________________________________________

SITE ADDRESS: ______________________________________________________________________________________

MODEL SERIAL NO.: ____________________________ FIRMWARE REVISION: _______________________________

1.ARE THERE ANY FAILURE MESSAGES? ____________________________________________________________

_____________________________________________________________________________________________________

_____________________________________________________________________________________________________

PLEASE COMPLETE THE FOLLOWING TABLE: (NOTE: DEPENDING ON OPTIONS INSTALLED, NOT ALL TEST

PARAMETERS SHOWN BELOW WILL BE AVAILABLE IN YOUR INSTRUMENT) *IF OPTION IS INSTALLED

PARAMETER	RECORDED VALUE	ACCEPTABLE VALUE
RANGE	PPB/PPM	100 PPB TO 2000 PPB
O3 STAB	PPB/PPM	< 0.3 PPB (RMS) WITH ZERO
		AIR
SAMPLE FLOW	CM3	500 ± 50
NO FLOW	CM3	5 ± 2
PMT SIGNAL WITH ZERO	MV	-20 TO 150
AIR
PMT SIGNAL AT SPAN GAS	MV	0-5000MV
CONC	PPB	0-20000 PPB
NORM PMT SIGNAL AT	MV	0-5000MV
SPAN GAS CONC	PPB	0-20000PPB
AZERO	MV	-20 TO 150
HVPS	V	400 – 900
RCELL TEMP	ºC	50 ± 1
BOX TEMP	ºC	AMBIENT + 3 -7ºC
PMT TEMP	ºC	7 ± 2ºC
RCEL PRESS	IN-HG-A	2-10 (constant)
SAMP PRESS	IN-HG-A	AMBIENT - 1 ± 1
NO PRESS	IN PSIG	5 ± 0.2
O3 SLOPE		1.0 ± 0.3
O3 OFFSET		-20 TO 150
ETEST	PMT MV	2000 ± 1000
OTEST	PMT MV	2000 ± 1000
	Values are in the Signal I/O
REF_4096_MV	MV	4096mv ±2mv and Must be
		Stable
REF_GND	MV	0± 0.5 and Must be Stable

TELEDYNE API CUSTOMER SERVICE

EMAIL: api-customerservice@teledyne.com

PHONE: (858) 657-9800 TOLL FREE: (800) 324-5190FAX: (858) 657-9816

07337B DCN6324 C-1