Manuals / Telex / Computer Equipment / Power Supply

Telex MS-2002 user manual External Audio Input and PA Output

Models: MS-2002

1 30

Page 18

FIGURE 6. External Audio Input and PA Output.

You can connect two (2) audio sources to the Program Inputs connector: one (1) for each channel. Audio sources can be directly connected with a user-supplied DB9M connector. For more information on the program input connector specifications, see “Specifications” on page 15. However, a more convenient method is to use an XP-USPG Breakout Panel as shown. The XP-USPG also interfaces the PA jack of the MS-2002 to a standard, 2-pin XLR audio cable.

NOTE: The SP-USPG Breakout Panel can be rack mounted using a BOP-1000 Rack Mount Plate.

Page 18

Image 18

Telex MS-2002 user manual External Audio Input and PA Output

Contents

9350-7749-000 Rev J Master Station and Power Supply User ManualMS-2002 1/2010See the enclosed warranty card for further details Important Safety Instructions Page OPERATION AND SPECIFICATIONS of ContentsINSTALLATION INTRODUCTIONPage Introduction DescriptionCHAPTER Features FIGURE 1. MS-2002 Reference ViewTo access internal switches, do the following InstallationConfiguration Pre-check CHAPTERDefault Switch #Settings DIP SWITCH SW1 INTERNALProgram Interrupt DIP Switches Headset Microphone Type Selection DIP SwitchMic Kill Send Enable DIP Switch Incoming Call Beep DIP SwitchesDirect Program Listen Enable / Disable Jumpers Monaural or Binaural Operation DIP SwitchesBalanced Unbalance Switches Settings for JumpersMounting ConnectionsExternal Program Input and PA Output Cables FIGURE 3. MS-2002 Monaural Master Speaker Station Configuration FIGURE 4. MS-2002 Binaural Master Speaker Station Configuration FIGURE 5. MS-2002 Typical Speaker Station and Belt Pack Connections FIGURE 6. External Audio Input and PA Output “Y” CABLE WIRING TYPICAL 1-CHANNEL CABLE WIRINGTYPICAL 2-CHANNEL CABLE WIRING FIGURE 7. Audiocom Intercom CablesPage Test Tone Operation and SpecificationsPower-Up Check CHAPTERSidetone Adjustment Normal vs. Programming Mode Voice-Activated Microphone VOX SetupOperation To check and set the VOX level, do the followingCall an Intercom Channel Volume AdjustmentReceiving Calls Microphone Mute During TalkAll Talk Using Mic KillPublic Address Turning the Program Inputs On and OffUsing Voice-Activated Microphone VOX Incoming Call Beep ON / OFFTo enable incoming call beep, do the following Dimensions SpecificationsGeneral Power Requirements WeightPA Output Output Level XLR-3 Unbalanced Configuration PinoutsXLR-6 Unbalanced Configuration Pinouts Speaker Output Output LevelQuick Reference Description Action