Telex MS-2002 instruction

FIGURE 4. MS-2002 Binaural Master Speaker Station Configuration.

A good configuration for smaller intercom systems when you want to operate the MS-2002 as a master speaker station, with a separate speaker for each intercom channel. Make sure the MS-2002 intercom DIP switches are set for binaural speaker operation on page 12. Also, set the Combine/Isolate switch to the Isolate position. With this setting, the two (2) intercom channels are completely separated. The internal amplified speaker is used as the speaker output for channel 1, and the SPK-2000 is used for channel 2.

16

Image 16

Telex user manual MS-2002 Binaural Master Speaker Station Configuration

Contents

Master Station and Power Supply MS-2002 See the enclosed warranty card for further details Important Safety Instructions Page Contents Page Introduction Description Features MS-2002 Reference View Installation Configuration Pre-check Switch # Description Settings Default Headset Microphone Type Selection DIP Switch Mic Kill Send Enable DIP SwitchProgram Interrupt DIP Switches Incoming Call Beep DIP Switches Monaural or Binaural Operation DIP Switches Balanced Unbalance SwitchesDirect Program Listen Enable / Disable Jumpers Settings for Jumpers Connections MountingExternal Program Input and PA Output Cables Page MS-2002 Binaural Master Speaker Station Configuration MS-2002 Typical Speaker Station and Belt Pack Connections Page Audiocom Intercom Cables Page Power-Up Check Operation and SpecificationsTest Tone Sidetone Adjustment MS-2002 Bottom View Voice-Activated Microphone VOX Setup OperationTo check and set the VOX level, do the following Tap the Mic Kill key To call an intercom channel, do the following To mute the microphone during talk, do the following Using Mic Kill Public AddressTo use the public address system, do the following To turn the program inputs on and off, do the following To enable incoming call beep, do the following Using Voice-Activated Microphone VOXIncoming Call Beep on / OFF Specifications General Power Requirements Speaker Output Output Level Quick Reference Description Action