Battery Installation
Ensure that the On/Off volume control knob is turned off.
Press down and hold down the battery release latch, slide the battery pack about 1/8 inch back, toward the latch, until it stops. Then lift battery pack out. Replace batteries as follows:
1. Open the battery pack by inserting fin- ger nail and lifting.
2.Pull battery strap to remove low or dead batteries.
3.Load new batteries following the polarity as shown in battery case
5. Be sure strap goes under batteries.
6. Tuck end of strap under door when placing the battery cover back on the case.
4. Start loading at the end of the case where
the strap is attached to the case.
Figure
Battery Installation
WARNING: Do not place an alkaline TR battery pack in any battery charger. Severe charger and batter pack damage may results.
