User Manual version 2.1
OPEN (660) 120/140/150
4-42
FDD/IDE board
HDD bracket
4.3.2. OPEN (660) 150 3.5" HDD Installation
The OPEN (660) 150 provides enough space to build in a
3.5” hard disk drive in the computer chassis. If the user
intends to attach a 3.5” hard disk or remove the existing
device for repair or for a higher-capacity one, the
following figure shows you the way to install an internal
HDD.
1. Detach and remove the rear cover.
2. Remove the CD-ROM/FDD module.
3. Take out the FDD/IDE board
4. Remove the whole HDD module.
5. Install the 3.5” HDD to the HDD bracket with screws.
6. Then, insert the whole unit to the system
compartment
7. Insert the CD-ROM/FDD/HDD board back again.
8. The are two IDE cables, one 44-44 pin IDE cable and
the other 40-40 pin cable. The 44 pin cable is used to
connect the 44 pin IDE connector on the IDE/FDD
board to the PC 660A2 primary IDE connector. Then,
Use the provided 40-pin IDE cable to connect the HDD
to the IDE connector on the FDD/IDE board. Match pin
1 of the HDD and pin 1 of the cable.
9. Make sure the CD-ROM cable, 16 pin FDD cable, 4 pin
audio cable and 5V power cable is properly connected
to all the connectors on the FDD/IDE board (Refer to
Sec. 4.2.2 for detailed figure for the FDD/IDE board).