User Manual version 2.1
OPEN (660) 120/140/150
4-44
4.4.2. Internal FDD installation for OPEN 150
Aside from connecting to an external FDD, the OPEN (660)
150 can also accommodate an internal slim type FDD,
depending on the system requirement. The floppy disk
drive used in the OPEN 150 II is a slim type FDD widely
used in notebook computers. To install the floppy disk
drive to the OPEN 150, refer to the following steps below:
1. Detach and remove the rear cover.
2. There is an FDD/CD-ROM bracket holding the FDD.
Remove the bracket. Place a slim type floppy disk
drive on the bracket. Fix the FDD on the bracket with
the 4 screws.
3. Use a 26 pin flat FDD cable to connect the FDD to the
FDD connector on the FDD/IDE board.
4. Make sure the 16 pin FDD cable, 4 pin audio cable and
5V power cable is properly connected from the OPEN
(660) to all the connectors on the FDD/IDE board.
FDD/IDE board for OPEN
(660) 150
44 pin IDE
connector
40 pin HDD
connector
2 pin 5V power
connector
4 pin audio power
connector
16 pin FDD connector
26 pin FDD connector
connector
50 pin CD-ROM
connector