User Manual version 2.1
OPEN (660) 120/140/150 4-41
4.3. Installing the HDD

4.3.1. OPEN (660) 120/140 2.5" HDD Installation

The OPEN (660) 120/140 provides enough space to build
in a 2.5” hard disk drive in the computer chassis. If the
user intends to attach a 2.5” hard disk or remove the
existing device for repair or for a higher-capacity one, the
following figure shows you the way to install an internal
HDD.
1. Detach and remove the rear cover. The HDD module is
located at the side of the system compartment
2. Remove the whole HDD module from the system
compartment.
3. Insert the 4 provided rubber cushions to the HDD
bracket first.
4. Glue the mylar insulator to the Hard disk drive
5. Install the 2.5” HDD to the HDD bracket with screws.
6. Then, insert the whole unit to the system
compartment.
7. Use the provided 44-pin IDE cable to connect the hard
disk drive to the system IDE connector. Match pin 1 of
the hard disk drive and pin 1 of the cable.