TERK Technologies 1DIRECTV installation manual Antenna Assembly Overview Contents of Package

Models: 1DIRECTV

1 12

Page 2

Image 2

Dish Mounting Hardware

Multi-Satellite Dish Reflector

LNB Arm/Antenna Back Assembly

Triple-head, Multi-Satellite	LNB Mounting Hardware	EZALIGN™ Mast
LNB with built-in Multi-Switch for
four Independent Outputs

Image 2

Contents

Installation Manual Introduction Safety Information Antenna Assembly Overview Contents of Package Tools Required Optional Accessories not includedSteps for Installation Following pages, you’ll find step-by-step instructions for Find your coordinates Connect your receiver to the TVSet the antenna type Azimuth Elevation Tilt If you live on the West Coast, Finding Suitable Antenna SiteDifferent location Sat C, 110 with Converted Transponders Align the mast Installing Ezalign MastMount the base securely Tighten mast bolts Set Elevation Adjustment Assembling/Adjusting Antenna on GroundSet Tilt Adjustment Attaching Antenna to Mast Connect to grounding block Routing RG 6 CablesRun cable from receiver Align the Azimuth Aiming Fine-tuning AntennaAttaching LNB to Antenna Mark the mast and antenna bracket point with a pencil Fine-tune the Elevation Verify satellite signalsVerify Azimuth alignment Fine-tune Elevation Troubleshooting Check List for Initial Installation Loss of Signal/Rain Fade Installation with Long Cable Run