Texas Instruments 51X c

2.5.5 Installing External Microphone

An external microphone can be attached to the notebook using the leftmost

audio connector (when viewed from the rear of the notebook). When the

external microphone is installed and the unit powered up, the inter nal

microphone is disabled.

2.5.6 Installing External Audio Input Devices

The middle audio jack on the rear of the notebook allows you to connect an

external sound source (e.g. tape player, radio, etc. ) to the notebook.

2.5.7 Installing External Audio Output Devices

The rightmost audio jack (when viewed from the rear of the notebook)

provides an audio line output cable of driving external head phones,

speakers or an external amplifier.

2.6 Installing the AC Power Adapter

Use the following procedures to connect the AC Adapter to the syst em:

cCaution: Use only the AC Adapter supplied with the computer; other

adapters can damage the unit.

1. Remove the AC adapter from the packaging. Connect the round coaxial

connector supplied with the notebook to the power rec eptacle on the

rear of the notebook as shown in Figure 2-9.

2. Connect the female side of the AC Power cord to the AC Adapter and

connect the male end to a grounded AC outlet

.

AC Adapter

AC Power

(120VAC to 230 VAC,

50 to 60 Hz)

Figure 2-9 AC Adapter Installation

2-10 Installation

Contents

Main Page Contents Preface 1 General Description 2 Installation 3 Operating Instructions 4 Theory of Operation 5 Troubleshooting Procedures 6 Field Service ASelf Test Error Messages BPC-Doctor Diagnostics Preface Introduction Intended Audience Contents Other Manuals About the System Ordering Parts and Supplies 1 General Description 1.1 1.2 Model 510 Model 515 1.3 Configuration P/N Suffix Configuration P/N Suffix 1.4 Page Figure 1-2 Extensa 51x Series Features 1-4 General Description 1.4.1 1.4.2 1.4.3 n 1.4.3.1 Controls and Indicators ^ 1.4.4 1.4.5 Status LEDs 1.4.6 1.5 1.6 Subassemblies 1.6.1 1.6.2 1.7 Specifications Table 1-3 Extensa 51x Notebook Features Specifications Model 510 Model 515 General Description 1-13 * Weight specifications do not include AC Adapter 1.8 2 Installation 2.1 2.2 n 2.3 c n 2.3.1 Page 2.3.2 2.3.3 2.4 c 2.5 2.5.1 2.5.2 2.5.3 c 2.5.4 2.5.5 2.5.6 2.5.7 2.6 c 2.7 2.8 2.9 2.10 3 Operating Instructions n 3.1 3.2 3.2.1 3.2.2 Status LEDs 3.2.3 3.2.4 3.3 3.3.1 3.3.2 3.3.3 3.3.4 3.3.5 3.3.6 3.3.7 3.3.8 n 4 Theory of Operation 4.1 4.2 4.2.1 MAIN BOARD Figure 4-1 Notebook Functional Block Diagram 4-2 Theory of Operation 4.2.2 4.2.3 4.2.3.1 External VGA Drive Capability c 4.2.4 c 4.2.5 4.2.6 4.2.7 Page Table 4-4 Primary Battery Pack Specifications Function Specifications 4-8 Theory of Operation 5 Troubleshooting Procedures 5.1 5.2 SEE PARAGRAPH 5.3.3 Figure 5-1 Troubleshooting Flowchart 5-2 Troubleshooting 5.3 5.3.1 (EG. a lamp) to verify that voltage is present. If the voltage is OK, try replacing the AC Adapter 5-4 Troubleshooting MAIN BOARD n 5.3.3 5.3.4 5.3.5 5.3.5.1 Interactive Tests Page 5.3.5.3 Creating a Bootable Floppy Diskette n 5.3.5.4 Running PC-Doctor Page 6 Field Service c 6.1 6.2 6.2.1 c 6.2.2 6.2.3 6.2.4 6.3 c 6.4 and Assemblies 6.4.1 Page 6.4.2 Table 6-2 Base Assembly, Field-Replaceable Units (FRUs) FRU Description Page CRU Description c 6.5 c Replacement Procedures 6.5.1 Pack 6.5.2 n c 6.5.3 6.5.4 6.5.5 Assembly 6.5.6 Hard Drive Cover HDD Release Latches 6.5.7 6.5.8 6.5.9 or Contrast Board c 6.5.10 6.5.11 Control Board 6.5.12 Supply Board Assembly 6.5.13 6.5.14 Page A Self Test Error Messages A.1 Error Messages A-1 Error Message Corrective Action Table A-2 POST Checkpoint List A-2 Error Messages Error Messages A-3 A-4 Error Messages Page B PC-Doctor Diagnostics B.1 B.2 B.3 B.4 B.4.1 B.4.2 n B.4.3 B.4.4 B.4.5 B.5 B.6