Texas Instruments TAS5727 quick start Connect the GUI to the EVM, I2C Memory Tool

Using the EVM Software www.ti.com

Figure 7. Main GUI Display

3 Using the EVM Software

3.1Connect the GUI to the EVM

Open the GUI by clicking Start → All Programs → Texas Instruments Inc → TAS57x → TAS57x GUI. Connect the MC57xxPSIA board (attached to the TAS5717EVM) to your PC with a USB cable. In the Properties window, select 1-band or 2-band DRC and select Stereo or Woofer. Stereo is selected for BTL and Woofer is selected for PBTL Mode.

The master volume is muted by default. Select the master volume block. Type the required volume in the Properties window.

Connect the GUI to the EVM hardware by clicking Target → Connect. This sends the initialization commands to the device. Un-check Shutdown and Mute. At this time, if connected properly, audio plays through the device. When the Connect command is issued, if an error appears indicating a USB problem, check the connections, and press the USB RESET button on the controller board. Then disconnect and re-connect from the Target menu.

3.2I2C Memory Tool

This tool can be opened from GDE (Tools → I2C Memory Tool) or independent of GDE from Start → Program → Texas Instruments Inc → Memory Tool.

Select I2C as shown in Figure 8.

Figure 8. Memory Tool Window

8	TAS5727 25W Digital Input Amplifier—with EQ and 2-Band DRC	SLOU299 –December 2010
		Submit Documentation Feedback

© 2010, Texas Instruments Incorporated