Troubleshooting
Step ➌
Install The Print
Head
To install the print head, first position it back over the platen. Lift the front slightly and insert the tension release rod under the metal tabs at the front edge. Lower the head down so that the ends of the rod drop into the slots on the sides of the carriage.
Next, install the head tension spring aligning it with the two posts on the print carriage. Ensure that the label guide near the rear of the print carriage is fully seated. Install the top head bracket on top of the spring, aligning it with the two posts on the print carriage. Insert the two screws removed earlier and tighten to secure the print head.
32 |
