The Speaker Company me240 manual Not Printing, Memory full, Flash / Dram, SD card is unable to use

		* Re-connect cable to interface.
		* If using serial cable,
		- Please replace the cable with pin to pin
		connected.
		- Check the baud rate setting. The default
		baud rate setting of printer is 9600,n,8,1.
		* If using the Ethernet cable,
		- Check if the Ethernet RJ-45 connector
		green LED is lit on.
		- Check if the Ethernet RJ-45 connector
		amber LED is blinking.
		- Check if the printer gets the IP address
		when using DHCP mode.
	* Cable is not well connected to	- Check if the IP address is correct when
	serial or USB interface or parallel	using the static IP address.
Not Printing	port.	- Wait a few seconds let the printer get the
	* The serial port cable pin	communication with the server then
	configuration is not pin to pin	check the IP address setting again.
	connected.	* Chang a new cable.
		* Ribbon and media are not compatible.
		* Verify the ribbon-inked side.
		* Reload the ribbon again.
		* Clean the printhead.
		* The print density setting is incorrect.
		* Printhead’s harness connector is not well
		connected with printheat. Turn off the
		printer and plug the connector again.
		* Check if the stepping motor is plugging in
		the right connector.
		* Check your program if there is a
		command PRINT at the end of the file and
		there must have CRLF at the end of each
		command line.
		* Delete unused files in the FLASH/DRAM.
		* The max. numbers of file of DRAM is 256
		files.
Memory full	* The space of FLASH/DRAM is	* The max. user addressable memory
		space of DRAM is 256 KB.
( FLASH / DRAM )	full.
		* The max. numbers of file of FLASH is 256
		files.
		* The max. user addressable memory
		space of FLASH is 2560KB.
	* SD card is damaged.	* Use the supported capacity SD card.
		* Insert the SD card again.
	* SD card doesn’t insert correctly.
SD card is unable to use		* The supported SD card spec and the
	* Use the non-approved SD card
		approved SD card manufacturers, please
	manufacturer.
		refer to section 1.1

35