3. On the Networking page, manually add N3200PRO IP address (i.e.
192.168.1.100) to the Trusted list.
Replacing Damaged Hard Drives
e
tic data recovery.
「RAID Damage」and system
drive in the N3200PRO:
disk tray then slide into the N3200PRO until it snaps into
When using RAID 1 or RAID 5 on the N3200PRO, you can use the auto-rebuild
on is
sent to specified receivers.
entioned above to replace the failed hard disk.
ile S k
he N3200PRO has a built-in utility that allows you to check the N3200PRO’s file
System Check utility, follow the steps below:
3. With the reset button held down, power on the system by pressing the
After that, the N3200PRO's WAN IP address will be reset to
192.168.1.100 temporarily. Please note that all file services at this time
will be stopped.
If you are using RAID 1 or RAID 5, you can easily replace a damaged hard driv
in the Thecus N3200PRO while keeping your data secure with the system’s
automa

Hard Drive Damage

W
beeps.
hen a hard drive is damaged, LCM will display

Replacing a Hard Drive

To replace a hard disk
1. Remove the tray with the damaged hard disk.
2. Insert the hard
place.
3. The LED solid green when the HDD is accessed.

RAID Auto-Rebuild

function when an error is detected.
1. When a hard disk fails the system beeps and/or an email notificati
2. Check the log message to see which disk has failed.
3. Follow the steps m
4. The system automatically recognizes the new hard disk and starts the
auto-rebuild sequence to resume its status before the hard disk crash.
F ystem Chec
T
system for errors. To use the File
86
1. Power off the N3200PRO.
2. With the unit powered off, press and hold the reset button.
WARNING
The File System Check utility works only with WAN and not LAN.
power button. You can release the reset button after 3 seconds alone with
2 beeps.