Thermador PD30 installation instructions Electrical Supply, Wall Connection

Step 2: Cabinet Preparation

ELECTRICAL SUPPLY

Installation of the range must be planned so that the rough-in of the junction box for the receptacle or conduit connection will allow maximum clearance to the rear of the unit.

When the power supply cord (not supplied) or conduit is connected to the mating receptacle or junction box cover, the combined plug/receptacle or junction box cover/conduit connector should protrude no more than 2-1/4" from the rear wall. See Figure 3B.

This is especially critical if the junction box in the wall will be directly behind the junction box on the unit when the unit is installed. Refer to Figure 8 on Page 14 for location of junction box on unit. To minimize binding when the unit is connected to the receptacle or junction box, orient the receptacle or conduit con- nector, and slide back into position.

FIG. 3B WALL CONNECTION

Power Cord & Receptacle Junction Box & Conduit

7