Thermador PD30 Installing Anti-TipDevice, and 36 Inch Ranges Figures 7A and 7B

Step 4: Installing Anti-Tip Device

30 and 36 Inch Ranges (Figures 7A and 7B)

Thermador Service Part No.	Qty	Description
415078	4	Screw, Phillips, #10 x 1-1/2"
487310	1	Anti-Tip Bracket, Floor-Mounted

IMPORTANT INSTALLATION INFORMATION:

• The anti-tip bracket may be attached to a solid	-	For walls or floors composed of drywall,
wood cabinet having a minimum wall thickness of		sheet-rock or other soft materials, drill 3/16"
3/4".		holes to a minimum depth of 1-3/4", then tap
• The thickness of the wall or floor may require use		plastic anchors into each of the holes using
		a hammer.
of longer screws, available at your local hardware
	-	For walls or floors composed of concrete or
store.
• In all cases, at least two (2) of the bracket mount-		concrete block, drill 3/16" holes to a mini-
		mum depth of 1-3/4", then tap concrete
ing screws must be fastened to solid wood or
		anchors into each of the holes using a
metal.
		hammer.
• Use appropriate anchors when fastening the
	-	For walls or floors having ceramic tile cover-
mounting bracket to any material other than hard-

wood or metal.		ing, drill 3/16" holes through the tile only, then
		drill into the material behind the tile as indi-
• Prepare holes at fastener locations as identified
		cated immediately above.
below:
		• If the range is moved to a new location, the Anti-
-	For walls, wall studs, or floors composed
		Tip Device must be removed and reinstalled.

of solid wood or metal, drill 1/8" pilot holes.

FIG. 7A - Mounting Anti-tip Bracket

MOUNTING ANTI-TIP BRACKET

The alternative floor mounted bracket shall be installed as follows:

a)Place bracket on floor in position shown in Figure 7B.

b)Secure to floor or wall stud.

c)Later, when the unit is installed, the adjustable leg will slide under the bracket.

FIG. 7B

➤

2-1/2"

➤

from edge of range

➤

➤ 2-1/2"

(typical - either side)

11