Thermo Products OHFA199DV5B, OHFA199DV5R A.Equal the required clearance with no protection

Fig. 7: Alternate constructions that allow reduced clearances to combustible materials.

REDUCTION OF CLEARANCES WITH SPECIFIED FORMS OF PROTECTION:

Type of protection applied to and covering all surfaces of combustible material within the distance specified as the required clearance with no protection unless otherwise noted, all dimensions in inches, refer to Fig. 7.

Required clearance with no protection from the appliance or		18 inches		9 inches		6 inches
		Sides &		Sides &		Sides &
chimney connector is:
		Above Rear		Above Rear		Rear
a.	3-1/2" thick masonry wall without ventilation air space….	--	12	--	6	--	5
b. 1/2" insulation board over 1" glass fiber or mineral wool batts…		12	9	6	5	4	3
c. 0.024(24 gauge) sheet metal over 1" glass fiber or mineral
wool batts reinforced with wire on rear face with ventilated air
space…		9	6	5	3	3	3
d.	3- 1/2" thick masonry wall with ventilation air space..	--	6	--	6	--	6
e.	0.024 (24 gauge) sheet metal with ventilated air space.	9	6	5	3	3	2
f. 1/2" thick insulation board with ventilation air space..		9	6	5	3	3	3
g. 0.024 ( 24 gauge) sheet metal with ventilated air space over
0.024 (24 gauge) sheet metal with ventilated air space….		9	6	5	3	3	3
h. 1" glass fiber or mineral wool batts sandwiched between two
sheets 0.024 (24 gauge) sheet metal with ventilated air space		9	6	5	3	3	3

A.Equal the required clearance with no protection.

B.Equals the reduced clearance permitted in accordance with the preceding clearance chart.

C.The protection applied to the construction that covers the combustible material should extend far enough in each direction to make C equal to A.

The vent connector pipe between the furnace and chimney shall be of equal diameter as the flue outlet of the furnace. The vent connector pipe must be made of 24 gauge (or thicker) corrosion-resistant steel. The vent connector pipe should be as short as possible and installed so that it has a continuous rise from the furnace to the chimney. The horizontal length of a connector to a natural draft chimney or vent serving a single appliance shall not be more than 75 percent of the height of the vertical portion of the chimney or vent above the connector. Elbows should be minimized and the pipe should be joined with metal screws and supported by straps. All horizontal runs of vent connector pipe should be pitched upward a minimum of ¼ inch per foot of run. A thimble should be used to connect the vent connector pipe to the chimney so the pipe may be readily removed in case of inspection or replacement. See Fig. 6 on preceding page.

9