(SBM-11)

OPERATION

2.4 Tractor Ballast

To ensure tractor stability when operating on flat surfaces the left rear tractor tire MUST exert a minimum down force (weight) of 1500 lbs. on the ground when the tractor is on level ground, its boom is fully extended and the mower head is horizontal and two feet above the ground. For units which have the ability to operate on either side of the tractor, these requirements must also be met for the right side tire when the boom is extended to the left side as described above. A tractor that does not meet this criteria is DANGEROUS and should not be operated as upset of the unit can occur resulting in possible serious injury and property damage. NOTE: All factory mounted units are tested and meet the ballast requirement before shipment; further testing is not required unless the unit is operated in a manner other than what is considered standard operating conditions.

For additional information on properly ballasting the tractor, refer to Alamo Industrial Tractor and Mower Stability Pamphlet P/N #02959010.

DANGER! Each Rear Wheel must have a minimum of 1500 pound contact with the surface to prevent lateral instability and possible tip-over which could result in serious bodily injury or even death. Widen the wheel tread and add weights if needed. Refer to the mounting instructions or call Customer Service if you need assistance with Counterweight Procedure.

If the unit is operated on slopes greater than 5°, additional counterweight will be required. Operation of the unit on slopes greater than 11° is not recommended under any circumstances. On a tractor with a 96” outside to outside tire spread, a 11° slope occurs when one rear tractor tire is about 8” lower than the other rear tire.

WARNING! Do not operate the unit under any circumstance if the slope is 10° or greater.

3. GETTING ON AND OFF THE TRACTOR

The operator must read and completely understand this manual and the tractor operator’s manual before starting any boom mower operation. If any part of either manual is not completely understood, consult an authorized dealer for a complete explanation. If the operator of the equipment can not read the manuals for themselves, it is the supervisors responsibility to read and explain the manuals and operating instructions to them.

RBF-14C 07/04

Operation Section 4-6

© 2004 Alamo Group Inc.

 

Page 56
Image 56
Tiger RBF-14C manual Getting on and OFF the Tractor, Tractor Ballast

RBF-14C specifications

The Tiger RBF-14C is a remarkable piece of engineering, designed for both performance and versatility in various demanding environments. This aircraft has gained recognition for its outstanding capabilities and is favored in a wide range of applications, including military operations, surveillance, and reconnaissance missions.

One of the primary features of the RBF-14C is its advanced propulsion system. Carefully crafted engines ensure high thrust and operational efficiency, allowing the aircraft to reach impressive speeds while maintaining fuel economy. This allows for extended range missions which is vital for operations requiring long flight durations without refueling.

The RBF-14C is equipped with a state-of-the-art avionics suite, incorporating the latest technologies in cockpit instrumentation. The digital displays provide pilots with crucial flight data and situational awareness, enhancing both safety and performance. This system integrates navigation, communication, and sensor data seamlessly, allowing for smooth operational command in challenging scenarios.

In terms of maneuverability, the RBF-14C is designed with advanced aerodynamics that optimize its performance in various flight conditions. The aircraft features a low-wing configuration, contributing to its agility and stability, making it adept at executing tight turns and rapid ascents. Such characteristics are particularly beneficial during aerial combat and evasive maneuvers.

Another significant aspect of the RBF-14C is its robust stealth capability. The airframe is designed to minimize radar cross-section and infrared signatures, enabling the aircraft to operate in contested environments while reducing the risk of detection. This stealth technology is crucial for missions requiring infiltration and precision strikes.

Moreover, the RBF-14C boasts enhanced payload capacity, allowing for the integration of a variety of munitions and sensors. This flexibility makes it suitable for diverse mission profiles, ranging from close air support to intelligence gathering. Pilots can quickly adapt the aircraft’s loadout based on mission requirements, contributing to its overall effectiveness.

Durability is another hallmark of the RBF-14C. Built with advanced composite materials, it can withstand harsh operational conditions, which enhances longevity and reduces maintenance needs. This reliability translates into lower operational costs over time, making it an advantageous choice for military and commercial operators alike.

In summary, the Tiger RBF-14C stands out as an exceptional aircraft, marked by its powerful engines, innovative avionics, exceptional maneuverability, stealth capabilities, diverse payload options, and durability. This combination of features solidifies its reputation as a leading aircraft in modern aviation, equipped to meet the challenges of today’s dynamic operational landscape.