Tiger RBF-14C manual Operating The Control Valves, Operation

(SG-29)

OPERATION

7. OPERATING THE CONTROL VALVES

The Rear Mount has two control valves. One is the on-off switch to the cutter motor and the other is the position control valve.

ON-OFF Switch (Mower Valve) - To operate the mower, pull the switch while the tractor is running. The push-pull operator will remain in the ON position PULLED or the OFF position PUSHED until the operator desires to start or stop the mower. Always start the cutterhead with the tractor at idle.

CAUTION! The operator should not leave his seat with this valve engaged or with the tractor engine running. Allow approximately 60 seconds for the blades to come to rest after turning the switch off before dismounting.

Push-Pull Switch

Schematic

Fuse & Holder

#16

Yellow

#12 BRN	Starter Solenoid Wire
#12 BRN	Starter Solenoid Wire
#16 RED	Switched Power Supply
#16 BLK	Ground

Shipped Loose in

Separate Plastic Bag

#12 Brown
#16 Black
(-)	#16 Red (+) to	Solenoid Connector
	Switched Power
	Supply
Ring Connector	Line Connector to
to Ground
	Starter Solenoid
	Parted Wires

The mower valve comes with a push-pull operator switch that, when properly installed, will prevent the tractor from starting if the switch is in the ON position (pulled out). To properly install the push-pull operator, follow the wiring diagram shown. Failure to properly install this switch could result in injury to the operator or bystander.

DANGER! Operate the Tractor and/or Implement controls only while properly seated in the Tractor seat with the seat belt securely fastened around you. Inadvertent movement of the Tractor or Implement may cause serious injury or death.

RBF-14C 07/04	Operation Section 4-14
© 2004 Alamo Group Inc.