Maintenance Section 4-25
MAINTENANCE
DAILY MAINTENANCE SCHEDULE

The following services should be performed daily or every 8 hours

of service, following the detailed maintenance instructions in the

operators manual.

______ Pump Drive Shaft: If required with drive shaft / coupler check for
end play and lubricate at zerks.
______ Crankshaft adapter: If equipped with rubber grommets check
condition, replace if missing or damaged.
______ Non-Greaseless Pivot points: Inject grease until it appears at ends.
(Check Maintenance Section)
______ Hydraulic fittings: Check for leaks with paper or cardboard. Tighten
fittings or replace hoses immediately.
______ Knives: Inspect for missing or damaged knives, change (only
complete sets) as needed.
______ Belts: Check / Tighten / Replace belts as needed.
______ Main Frame / Deck: Unless otherwise specified retorque bolts
according to torque specifications in this
section.
______ Hydraulic Fluid Level: Add, if required, per fluid recommendations.
______ Rear Flail Drive, Bearing
Flange and Shaft Couplers: Grease as instructed in the detailed
(if applicable) maintenance section.
______ Cutter Shaft and Ground Roller: Grease as instructed in the detailed
maintenance section
Service performed by:_______ Date:____/____/____ Hour
Meter:__________
Maintenance Section
** This page may be copied and used as part of the daily maintenance routine.