10.3. Mounting the Enclosure to the Rigging Frame

Flying Plates are mounted to the front and rear of the enclosure’s sides. Follow the procedures below to mount the enclosure to the Rigging Frame, as shown in the assembly diagrams.

Fix a supplied Joint Plate securely to the right side of the Rigging Frame, and another Joint Plate to the left side of the enclosure, each using 4 supplied bolts with plain washers and spring washers. Before securing the Joint Plate, determine whether the enclosure’s horn will face right or left. (This is not required for the SR-A18B Subwoofer). When stacking the subwoofer, install the system so that the subwoofer is positioned at the bottom (directly above the Rigging Frame).

High box assembly diagram

Subwoofer assembly diagram

Join the enclosure to the Rigging Frame securely, using 4 supplied bolts with plain washers and spring washers on each side (see the assembly diagrams below). For selecting holes in the Joint Plate to be used, refer to the section “10-6 Tilting the enclosure downward” described later .

High box finished assembly diagram

(Left side)

(Right side)

Subwooter finished assembly diagram

(Left side)

(Right side)

19

Page 19
Image 19
TOA Electronics SR-A12SWP, SR-RF12 Mounting the Enclosure to the Rigging Frame, Subwooter finished assembly diagram