TOA Electronics manual Setting UP Your TS-200 Phone, Configure the Line Access Mode

T S - 2 0 0 U S E R G U I D E

SETTING UP YOUR TS-200 PHONE

Before you can start using your TS-200 telephone, you will need to do the following:

1.Configure your line access mode

2.Enable headset operation if you’re using a headset.

3.Set the date and time.

CONFIGURE THE LINE ACCESS MODE

When you first power up the phone, the display will show DIRECT LINE? with options YES and NO.

•If this extension is configured so that you don’t need to dial 9 to place external calls, then select YES.

•If you dial 9 before placing external calls, then select NO.

Once set, the phone will automatically adjust redial, speed dial and Caller ID dialing accordingly.

If the phone doesn’t display the DIRECT LINE? prompt, toggle the PBX/Standard switch from PBX to Standard back to PBX. The switch is located on the right side of the phone as shown in the picture. The phone will then prompt you for direct line selection.

NOTE: Ensure that the PBX/Standard switch

is in the PBX position when you are done.

HEADSET OPERATION (OPTIONAL)

PBX Switch

If you are using a headset, you will need to configure your telephone to operate in headset mode. Configuring the TS-200 for headset mode allows you to place calls using the headset without the need to lift the handset.

The TS-200 supports 2 types of headsets:

Headsets with RJ22	Headsets with 2.5mm connectors
(handset) connectors

4 W W W.T A L K S W I T C H . C O M