Toastmaster MBT208, MBT240 warranty Control Panel Functions Programming Mode

Programming

The Batch Toaster is pre-programmed with standard menu programs at the factory. Perform the following steps ONLY if you wish to change a program’s settings.

IMPORTANT

Programming a new menu program will OVERWRITE an existing program. Do not overwrite a program that you wish to keep!

Refer to Figure 5 for an illustration of the controls used to program a menu selection.

1.Select a Program to Change

a.Push and hold the appropriate key. Af- ter 2 seconds, the control will beep once,

showing that the program has been selected.

DO NOT RELEASE THE KEY AT THIS TIME.

b.Continue to hold the key until the control

beeps twice and the display shows . Release the key. The “P” shows that

programming mode is now active, and “#:##”

is the currently-programmed set time. The

green light above the key will also flash to inform you which program will be changed.

2.Adjust the Set Time and Relays

NOTE

The toaster regulates heat through three relays. Each relay controls four of the twelve heating elements. Switching the relay on or off will also switch the four heating elements on or off. This allows the operator to adjust the toasting temperature.

Setting the relays to different on/off combinations for different menu programs allows the toaster to accomodate a variey of toasting temperatures.

Refer to the electrical wiring diagram at the back of this Manual for a listing of the heating elements that are controlled by each relay.

When programming mode is active, push the key to toggle the display between the

following settings:

a.

“#:##” is the currently-programmed set time. When this display is shown, the set time can

be adjusted using the and keys.

b. or

Shows whether Relay 1 (and the heating elements that it controls ) is currently on (“on”) or off (“--”). When this display is shown, Relay 1 can be toggled on or off as desired with the or keys.

c. or

Displays the current setting for Relay 2 (and the heating elements that it controls). This setting can be changed as desired with the or keys.

d. or

Displays the current setting for Relay 3 (and the heating elements that it controls). This setting can be changed as desired with the or keys.

If necessary, you can continue to press the key to repeat the cycle.

3.Save Changes and Return to Operating Mode

When your changes are complete, press the key to save the changes. The toaster will return

to normal operating mode. Access the new

program by pressing the appropriate key.

Figure 5 - Control Panel Functions: Programming Mode

	Display:	STOP/START key:
Shows changes to the set time and relay settings		Locks in changes to a program

Green lights: Flash to show	PROGRAM 4 key:	PROGRAM 5 and 6 keys:
that a menu program (1-6) is	Toggles display between time	Adjust the set time up or down,
being programmed	and Relay 1, 2, and 3 settings	or toggle relay settings on or off

7