TROUBLESHOOTING
PROBLEM | PROBABLE CAUSE | CORRECTIVE ACTION |
| |
|
|
|
| |
Product is toasted | Toaster was not adequately | Allow toaster to preheat until | (ready) ap- | |
too dark or too | preheated. | pears in the display. This should occur about 15 | ||
light. |
| minutes after electrical power is restored to the | ||
|
| toaster. |
|
|
|
|
| ||
| Preset toasting time is incor- | Enter Programming Mode to increase or decrease | ||
| rect. | the toasting time as necessary. Refer to the Pro- | ||
|
| gramming section of this Manual. |
| |
|
|
| ||
| Using refrigerated or frozen | Bakery products must be at room temperature BE- | ||
| bakery products. | FORE toasting for consistent results. | Allow a 2- | |
|
| |||
|
|
|
| |
Bakery product is | Loading is excessive. | Switch the | switch to the OFF (“O”) position. Wait | |
jammed in toaster. | OR | for the fan to stop operating. Then, switch the circuit | ||
| Product is loaded incorrectly. | breaker/fused disconnect to the OFF (“O”) position | ||
| OR | and allow the toaster to cool. |
| |
| Carbonized deposits on | Next, carefully clear the jam using a long object as | ||
| lower deck are sticking to the | |||
| a probe. The probe should preferably be made of | |||
| bakery product. | |||
| wood, which is less likely to damage the heating | |||
|
| |||
|
| elements. |
|
|
|
| WARNING |
| |
|
| NEVER USE A PLASTIC OR METAL | ||
|
| OBJECT AS A PROBE TO CLEAR A JAM. | ||
|
| WARNING |
| |
|
| DO NOT INSERT THE HANDS INTO THE | ||
|
| TOASTING CHAMBER TO CLEAR A JAM. IF THE | ||
|
| UNIT HAS NOT COMPLETELY COOLED, SEVERE | ||
|
| INJURY MAY RESULT. |
| |
|
| After clearing a jam, thoroughly clean the peel and | ||
|
| the lower deck before resuming operation. Refer to | ||
|
| Cleaning the Peel and Lower Deck in this Manual. | ||
|
|
|
| |
Toaster overheats | Cooling fan is dirty or inop- | Switch the | switch to the OFF (“O”) position. Wait | |
and shuts down. | erative. | for the fan to stop operating. Then, switch the circuit | ||
|
| breaker/fused disconnect to the OFF (“O”) position | ||
|
| and allow the toaster to cool. |
| |
|
| Thoroughly clean the fan before resuming operation. | ||
|
| Refer to Cleaning the Toaster in this Manual. | ||
|
|
|
| |
| High Limit system has acti- | Switch the | switch to the OFF (“O”) position. Wait | |
| vated, shutting down the | for the fan to stop operating. Then, switch the circuit | ||
| toaster. | breaker/fused disconnect to the OFF (“O”) position | ||
|
| and allow the toaster to cool. |
| |
|
| Restart the toaster, following the procedure in the | ||
|
| |||
|
|
|
|
|
If the problem persists, or is not described above, contact your Authorized Service Agent.
9