Toastmaster MBT240 Close, Removing the Lower Deck, Cleaning the Fan, Caution - Hot Surfaces

Models: MBT208 MBT240

1 16
Download 16 pages 61.92 Kb
Page 8
Image 8
Close

Close

1.Switch the Figure 6 - Removing the Lower Deck switch to the OFF (“O”) position. The fan will remain in operation to allow the toaster

to cool.

2.After the fan stops, switch the circuit breaker/fused disconnect to the OFF (“O”) position.

3.Cleaning the Peel and Lower Deck

CAUTION - HOT SURFACES

DO NOT TOUCH HOT SURFACES ON THE TOASTER. DO NOT REACH INTO THE TOASTING CHAMBER UNTIL THE UNIT HAS COOLED THOROUGHLY.

a.Remove the lower deck from inside the toaster. To remove the lower deck:

Pull the door handle forward to open the door.

Lift the front edge of the lower deck, and then pull it forward and out of the toaster. See Figure 6.

Release the door handle.

b.Wash the peel and the lower deck using a hot solution of McD All Purpose Concentrate (APC) (HCS). If necessary, scrub these com- ponents using a McD No Scratch Pad to re- move discolorations.

c.Rinse the peel and lower deck thoroughly.

d.Immerse the peel and lower deck in McD Sink Sanitizer Solution (HCS). Use 1 pack of so- lution for 10 gallons of water.

e.Remove the parts from the sanitizer solution, and allow them to air dry.

Figure 6 - Removing the Lower Deck

1. Pull door

handle forward

2. Lift front

edge of

lower deck

4. Release

door handle 3. Pull lower deck forward

4.Cleaning the Toaster

WARNING

WHEN CLEANING THE TOASTER, NEVER APPLY ENOUGH LIQUID TO STAND IN PLACE ON THE UNIT. DO NOT SPRAY, RINSE, OR SUBMERGE THE TOASTER. EXCESSIVE MOISTURE IN THE UNIT WILL CAUSE A SE- VERE ELECTRICAL HAZARD AND MAY OTH- ERWISE DAMAGE THE TOASTER.

CAUTION

DO NOT clean your toaster using abrasive clean- ers or pads. Both will scratch and dull the finish.

a.Thoroughly clean the fan (on the back wall of the toaster) using a stiff nylon brush. See Fig- ure 7.

CAUTION

The fan must be cleaned regularly. If the fan is blocked or plugged, bakery products will not be properly toasted and the toaster’s interior components may be damaged.

b.Wipe the exterior of the toaster with a clean, sanitized towel dampened with a hot solution of McD All Purpose Concentrate (APC) (HCS), as drawn from the sink proportioner.

c.Wipe the exterior of the toaster with a clean, sanitized towel dampened in water to remove any residual foreign material or cleaning so- lution. Ensure that all visible moisture has been removed from the unit.

d.Allow the exterior of the toaster to air dry.

5.Replace the lower deck inside the toaster.

6.Store the peel in a clean, dry location underneath the toaster.

7.Pull the door handle forward to open the door. Check that the back side of the door is slippery to the touch. If necessary, apply a thin coating of McD Bun Toaster Release Agent (HCS) to the back side of the door using a paper towel.

Figure 7 - Cleaning the Fan

8

Page 8
Image 8
Toastmaster MBT240, MBT208 warranty Close, Removing the Lower Deck, Cleaning the Fan, Caution - Hot Surfaces