SET-UP, OPERATION, AND CLOSE PROCEDURES
CAUTION - HOT SURFACES
DURING OPERATION, THE PEEL AND TOASTER ARE HOT. USE CAUTION AS YOU HANDLE THE PEEL AND OPERATE THE TOASTER TO AVOID INJURY.
Setup
1.Replace the lower deck inside the toaster.
2.Switch the circuit breaker/fused disconnect to the ON (“I”) position.
3.Switch the switch to the ON (“I”) position. The
display will flash as the toaster
IMPORTANT
If electrical power to the toaster is briefly inter-
rupted, hold down the | and | keys while | |
switching the | switch to the ON (“I”) position. |
This bypasses the normal 15 minute
4.Allow the toaster to
the toaster has finished
Operation
1.Push and hold the appropriate key (Program Key) for 2 seconds, until the control beeps once.
The green light above the key will illuminate to show that the program has been selected.
2.Load the bakery product onto the peel, with the cut side facing UP.
3.Pull the door handle forward to open the door.
4.Slide the peel into the toaster to load the product.
5.Release the door handle to allow the door to close.
8.Wait for the preset time to elapse. The control will beep 5 times at
preset time reaches , and the display will flash to show that the end of the preset time has been reached.
9.Push the key.
10.Pull the door handle forward to open the door.
11.If you removed the peel in Step 6, insert it into the toaster and underneath the bakery product.
12.Remove the peel (now holding the bakery prod- uct) from the toaster.
CAUTION
When the preset time elapses, the bakery prod- uct is correctly toasted. Leaving the product inside the toaster after the first beep sounds will begin to burn the bakery product. The fol- lowing alerts will sound if the product is left inside the toaster:
•The control will beep 5 times as described above. The product is correctly toasted when the first beep sounds.
•Next, the control will beep very rapidly for another 5 seconds.
•Next, the control will sound a continuous tone
until the key is pressed and the prod- uct is removed.
Always remove the product promptly when the first beep sounds!
13.Remove the bakery product from the peel.
14.Proceed as follows:
•If you will be toasting another batch of the same bakery product, go back to Step 2.
•If you will be toasting another type of bakery product, go back to Step 1.
6.During toasting, the peel can either be left inside the toaster, or removed, as you prefer. If you wish to remove the peel, slide it out of the toaster while hold- ing the door handle in the closed posi- tion. The closed door will hold the bak- ery product inside the toasting cham- ber.
7.Push the key. The digital timer will begin counting down.
•During idle periods, store the peel in a clean, dry location underneath the toaster.
Figure 4 - Control Panel Functions: Operating Mode
Display: Displays the remaining set time, a “ready” | STOP/START key: | |||||||||
indication, or diagnostic information, as appropriate | Starts/stops a program | |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Green lights: Illuminate to | PROGRAM | POWER ON/OFF (“I/O”) |
show that a menu program | Select a menu program | switch: Switches the |
| toaster on (“I”) and off (“O”) |
6