coffee.

10.Remove the cup of coffee which is now ready.

11.Pull the gearlever on the right hand side towards you to release the pod assembly and remove the used coffee pod.

Each coffee pod makes a single cup of coffee.

Once the machine has reached its normal operating temperature the red LED light on the left hand side of the machine will go out. After this you can use the machine to make coffee. The LED light may come back on again to indicate that the boiler is re-heating but once you have made your first cup you can continue to use the machine and do not need to wait for the LED to go off if you are using the water.

NOTE: Unwrap the pods just before using them to retain maximum freshness.

4.4. DISPENSING HOT WATER

The machine can be used to dispense hot water for tea or other drinks. To dispense hot water proceed as follows:

1Turn on the machine and wait for the red LED light on the left and side to go out to indicate that the water in the boiler has reached operating temperature (95°C)

2Place the cup or container under the steam arm.

3Carefully open the steam release knob and press the water button (NOT the steam button)

4When you have sufficient hot water press the water button again to stop the water.

5Fully close the steam release knob.

ATTENTION: When hot water is being dispensed from the steam arm it will be very hot. Avoid touching the metal arm and use the plastic lug to move it around.

18 – TONINO LAMBORGHINI EPS

Use and maintenance manual – Rev.01 - 07/2006