Topcom 1000 manual Butler

Butler 1000

•‘SEARCHING’ and the symbol appears on the display.

•The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal sounds when the handset has found the base unit.

•Press the Programming key .

•‘PIN’ appears on the display.

•Enter the 4-digit PIN code of the base unit in (default PIN code is ‘0000’). Use the number keypad.

•Press the Programming key .

•The handset is subscribed to the base unit.

4.22Subscribing Butler 1000 handset on Butler 575/575+ & Cocoon100/100+ & Butler 2000 base unit

Press the Paging key on the Butler 575/575+ or Cocoon100/100+ or Butler 2000 base unit for +/- 15 seconds until you hear a beep. The base unit is now in subscribing mode. For 1

minute, the base unit is in subscribing mode and you have to do the following to subscribe the handset:

•Press the Programming key .

•Press the Up or Down key repeatedly until ‘BASE SUB’ appears on the display.

•Press the Programming key .

•‘BASE _‘ appears on the display.

•Enter a number for the base unit to which you would like to subscribe the handset (1-4). Use the number keypad.

•‘SEARCHING’ and the symbol appear on the display.

•The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal sounds once the base unit is found by the handset.

•Press the Programming key .

•‘PIN’ appears on the display.

•Enter the 4-digit PIN code of the base unit (default PIN code is ‘1590’). Use the number keypad.

•Press the Programming key .

•The handset is subscribed to the base unit.

4.23Subscribing a Butler 1800T handset to a Butler 1000 base unit

The below procedure only applies to a Butler 1800T handset and Butler 1000 base unit!! Press the Paging key on the base unit for 10 seconds until the Line/Charge indicator

op the base unit starts to blink quickly. The Line/Charge indicator will blink quickly for one minute. During this minute, the base unit is in subscribing mode and you must do the following to subscribe the handset:

•Press the key once.

•Press the OK key and select a base unit (1-4) with the keys.

•Press the OK key.

•Enter the PIN code of your base unit. Usually: 0000.

•Press OK. The Butler 1800T now searches for your DECT base unit. As soon as it finds it, you will see the identification code of this base unit on the display.

•Press OK to confirm your selection or press ESC to cancel the subscription.

64