Topcom Butler 5500
4 Topcom Butler 5500
1 GETTING STARTED

1.1 INSTALLING THE BASE

For installation, do the following:
•Plug one end of the adaptor into the outlet and the other end into the adapter jack on the
bottom of the telephone.
• Connect one end of the telephone cord with the wall phone jack and the other end to the
bottom of the telephone.
•Put the telephone-and AC power line cord in the base quides as shown on the picture below:

1.2 INSTALLING THE HANDSET

•Open the battery compartment (see below).
•Insert the batteries respecting the (+ and -) polarity
.
•Close the battery compartment.
•Leave the handset on the base unit for 20 hours. The Line/Charge indicator (LED) on the base unit will light
up.
Before you use the telephone for the first time, you must first make sure the battery is charged for 20 hours. If you do
not do this, the telephone will not work optimally.

1.3 IF YOU HAVE PURCHASED A TWIN/TRIPLE VERSION

If you have purchased a Twin or triple verion
•Plug one end of the adaptor into the outlet and the other end into the adapter jack on the bottom of the charger.
•Insert the battries inside the handset
•Charge the handset for at least 20 hours.
Power cable
Telephone cord
TEL
+
-
-
+
Rechargeable
Batteries
back view of hand-set
Cover
B5500_Eur.Book Page 4 Tuesday, September 14, 2004 2:26 PM