Topcom Allure 200
1 BUTTONS/LED
1 | ‘Handsfree’ indicator |
| 10 | Dial / Alarm button / | ||
2 | ‘New Calls’ indicator |
| 11 | Flash | ||
3 | Direct Memory buttons | 12 | Mute button | |||
4 | Music on Hold button |
|
|
| 13 | Redial / Pause button |
5 | Volume Down / VIP button | /VIP | 14 | Handsfree button | ||
6 | Volume Up / Delete button | / | 15 | Alphanumerical keyboard | ||
7 | Phone Book button |
| 16 | Ring volume switch | ||
8 | Up button |
| 17 | Flash time switch | ||
9 | Down button |
| 18 | Telephone line input | ||
2 DISPLAY
Display information | Description | ||
|
|
| You received new messages in the telephone network mailbox |
XX NEW | You have received ‘XX’ new messages in your call list | ||
REP | You have received the call more than once | ||
VIP | You have selected the number as VIP | ||
|
|
| The battery is almost empty and needs to be replaced |
|
|
| The handsfree function is activated |
|
|
| The alarm is enabled |
|
|
| |
3 INSTALLATION
3.1Battery installation
•Put batteries in the battery compartment to activate the display :
-Open the battery compartment at the bottom of the unit using a screwdriver.
-Insert 3 AAA Alcaline batteries (1,5V).
-Close the battery compartment.
Connect one end of the line cord to the telephone line wall socket and the other end to the bottom of the phone.
Note:When the battery indicator 
is shown, the batteries must be replaced. When the batteries are removed, you have 5 minutes to replace them. After that time, the memory will be lost.
Never change batteries when the telephone line is connected !
3.2 Initialization
a. Display language
After installing the batteries, the default display language is shown.
•Use the Up 
or Down 
button to select the desired display language.
•Press the Handsfree button 
to go to the next setting ‘Memory capacity’
b. Memory capacity
The maximum capacity of the Allure 200 is 110 entries including names and numbers.
This number can be dedicated to the Phonebook and/or the Caller ID list. In this setting you have to select the capacity of the Phonebook.
•Use the Up 
or Down 
button to select the phonebook memory ‘MAX DATABANK = XXX (default 032)’
•Press the Handsfree button 
to confirm the phonebook memory.
•The Caller ID list memory size will be displayed briefly and the unit will go to standby mode.
To have access to the memory setting, you have to remove the batteries for more than 10 minutes. All stored information will be erased after initialisation.
4 | Topcom Allure 200 |
