•Lightly tap the hex nut to dislodge the ball bearing
from the right side of frame before removing the hex nut and bell washer from left end of shaft.
Track
O
Figure 20
•Move the gear shaft to the right and slide the friction wheel assembly from the shaft. See Figure 21A.
•Remove the four screws from the friction wheel assembly. See Figure 21B.
•Remove the friction wheel rubber from between the friction wheel plates.
•Reassemble new friction wheel rubber to the friction wheel plates and hub, tightening the four screws in rotation and with equal force.
•Position the friction wheel assembly up onto the pin of the shift rod assembly, and slide the shaft through the assembly. Reassemble in reverse order.
Engine
Refer to the separate engine manual packed with your unit for all engine maintenance procedures.
A |
| Shift Rod |
|
| Assembly |
| Spacer | _procket |
|
|
Assembly
BScrews
Friction Wheel Rubber
/
/,
/'
Hub ..'
,/
/'
/
/
Friction Wheel z
Plates
Figure 21
0ff-Seas0nStorage
fuel container indoors where there is an
WARNING: Never store the machine or open flame, spark, or pilot light such as on
water heater, furnace, clothes dryer, or other gas appliance.
container outdoors, away from an open
,_ WARNING: Drain fuel into an approved flame. Allow engine to cool. Extinguish
cigarettes, cigars, pipes, and other sources of ignition prior to draining fuel. Fuel left in engine for extended periods
deteriorates and will cause starting problems.
If unit is to be stored over 30 days, prepare for storage as follows:
•Remove gasoline from carburetor and fuel tank to prevent gum deposits from forming on these parts and causing possible malfunction of engine.
•Run engine until fuel tank is empty and engine stops due to lack of fuel.
•Drain carburetor by pressing upward on bowl drain, located below the carburetor cover.
16