Ifnotalreadyattached,slipthecablesthatrunfrom thehandlepaneltothechuteassemblyintothe cableguidelocatedontopoftheengineSee. Figure3.
CableCable
Guide
J
_ute
Figure 3
If not already attached, unwrap the headlight wire which is attached to the headlight, beneath the handle panel. Wind the headlight wire around the lower right handle until excess slack is removed. See Figure 4.
•Plug the wire from the headlight into the alternator
lead coming from the right side of the engine underneath the fuel tank.
Alternator Lead
Lar_
NOTE: Wheels are omitted from illustration for clarity.
Figure 4
Clean-0utT001
•This tool, along with the electric cord, is fastened with a cable tie to the rear of the auger housing for shipping purposes. Cut the cable tie and remove the electric cord before operating the snow thrower.
SECTION3: KNOWYOURSNOWTHROWER
Drive Control / Aug
Switchf
Headlic
Chute
_Shift Lever.,
_ _Chute Tilt _Control
_T | Heated Gript |
AaUcgkerst_r_ _ OntrOI
Control
Primer
Choke_@_
Chute Directional
ControlK
Ignition Key
Thr )ttle
t Model 1028 Control
tt Model 1130 equipped with one (1)
Electric
Starter
_RI_ Butt°n
Switch
ox
ecoil
YStarter
......... Handle
i ji
Fuel
*If Equipped
Figure 5
WARNING: Read, understand, and follow | DriveControl/ AugerControl Lock |
all instructions and warnings on the machine and in this manual before
operating.
The drive control is located on the right handle. Squeeze the drive control to engage the wheel drive. Release to stop. See Figure 5.
