NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Do not drain carburetor if using fuel stabilizer.
•Wipe equipment with an oiled rag to prevent rust.
•Remove spark plug and pour one ounce of engine oil through spark plug hole into cylinder. Cover spark plug hole with rag. Crank engine several times to distribute oil. Replace spark plug.
•Follow the lubrication recommendations found in the Maintenance Section.
•Always store the snow thrower in a clean, dry area.
NOTE: When storing any type of power equipment in an unventilated or metal storage shed, care should be taken to rust proof the equipment. Using a light oil or silicone, coat the equipment, especially any chains, springs, bearings, and cables.
SECTION8: TROUBLESHOOTING
Problem
Engine fails to start
Engine runs erratic
Loss of power
Excessive vibration
Unit fails
to propel itself
Unit fails
to discharge snow
Cause
1.Fuel tank empty, or stale fuel.
2.Blocked fuel line.
3.Choke not in the ON position
4.Faulty spark plug.
5.Safety key not in ignition switch on engine.
6.Spark plug wire disconnected.
7.Primer button not being used properly.
8.Fuel
1.Unit running on CHOKE.
2.Blocked fuel line or stale fuel.
3.Water or dirt in the fuel system.
1.Spark plug wire loose.
2.Gas cap vent hole plugged.
1.Loose parts or damaged auger.
1.Drive control cable in need of adjustment.
2.Drive belt loose or damaged.
1.Chute assembly clogged.
2.Shear pin sheared.
3.Foreign object lodged in auger.
4.Auger control cable in need of adjustment.
5.Auger belt loose or damaged.
6.Shear pin(s) sheared.
Remedy
1.Fill tank with clean, fresh gasoline. Fuel becomes stale after thirty days.
2.Clean the fuel line.
3.Move switch to the ON position
4.Clean, adjust gap or replace.
5.Insert the key fully into the switch.
6.Connect spark plug wire.
7.Refer to the engine manual.
8.Open fuel
1.Move the choke lever to OFF position.
2.Clean the fuel line; fill the tank with clean, fresh gasoline.
3.Drain the fuel tank and carburetor. Refill with fresh fuel.
1.Connect and tighten spark plug wire.
2.Remove ice and snow from gas cap. Be certain vent hole is clear.
1.Stop the engine immediately and disconnect the spark plug wire. Tighten all bolts and nuts. If vibration continues, have the unit serviced by an authorized service dealer.
1.Adjust drive control cable. Refer to Making Adjustment Section.
2.Replace drive belt. Refer to the Service Section.
1.Stop engine and disconnect spark plug wire. Clean chute and inside of auger housing with
2.Replace shear pin.
3.Stop engine immediately and disconnect spark plug wire. Remove object from auger with
4.Adjust auger control cable. Refer to the Making Adjustments Section.
5.Refer to Service Section.
6.Replace shear pin(s).
17