Toro 38583, 38584 owner manual Setup, Unfolding the Handle

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.

Procedure	Description	Qty.	Use
1.	No parts required	–	Unfold the handle.
2.	Screws	3	Install the discharge chute.
	Chute assembly	1

1. Unfolding the Handle

Procedure

1.Loosen the lower handle knobs, pull out the handle bolts until you can move the handle freely, and rotate the handle to the operating position (Figure 3).

Important: Ensure that you do not pinch or kink the control cable or the Quick Shoot™ cables (Figure 5).

Figure 5

1. Control cable 2. Quick Shoot™ cables

Figure 3

1. “U”-shaped handle lock (2) 2. Handle knobs

2.Insert the end of the “U”-shaped handle lock into the open hole in the handle and tighten the handle knobs until they are snug (Figure 4).

Figure 4

5