Note: The position of the PROGRAMS switch does not determine which program will run during automatic controller operation. In other words, if a program has an assigned watering day schedule, start time and a station with run time, it will operate automatically regardless of the position of the PROGRAMS switch.
Manual Mode
Manual mode enables automatic watering programs and their assigned stations to be operated at any time.
Note: Once watering has started, refer to page 32 for additional manual control operations.
Note: Upon completion of a Manual mode operation, the controller will return to the Automatic mode.
Operate Watering Program(s)
Confirm that the control dial is in the RUN 
position.
Position the PROGRAMS switch to select a program.
Press the MANUAL START button two times to start the program watering cycle. The first active station number and the Watering On 
symbol will begin flashing.
4.To select additional programs, repeat steps 
and 
. Note: Additional programs are stacked (staged to run sequentially) in the order they are selected.
The watering program identifier (A, B or C) will be displayed as each program is selected. The program currently operating is indicated by the flashing program identifier. As one program finishes, the next program in the stacked sequence will start.
Flashing |
Operate Selected Stations
Confirm the control dial is in the RUN 
position.
Position the PROGRAMS switch to select a program.
Press the MANUAL START button one time.
The station numbers assigned to the program will be displayed. The first station number in sequence will begin flashing. To select the station(s) to operate, use the following procedure:
•To select the station, press the +/ON button.
•To skip the station press the
When the desired station numbers are displayed, press the MANUAL START button one time to start watering. The active station number and the Watering On 
symbol will begin flashing.
31
