Toshiba 32HL85 owner manual Adding channels to the TVÕs memory, Programming channels automatically

Setting up your TV

Adding channels to the TVÕs memory

When you press Channel y or z, your TV will stop only on the channels you programmed into the TVÕs channel memory.

Follow the steps below and on the next page to program channels into the TVÕs memory.

Programming channels automatically

Your TV can automatically detect all active channels in your area and store them in the channel memory. After the channels are programmed automatically, you can manually add or erase individual channels (see page 25).

To program channels automatically:

1.Press MENU, and then press x or • until the SET UP menu appears.

2.Press y or z to highlight TV/CABLE.

3.Press x or • to select either TV (if you use an antenna) or CABLE (if you use cable channels).

SET UP	1/2
LANGUAGE	ENGLISH
TV/CABLE	CABLE
CH PROGRAM	ENTER
ADD/ERASE	ADD
CH LABELING	ENTER
VIDEO LABEL

MENU BACK EXIT WATCH TV

4. Press z to select CH PROGRAM.

SET UP	1/2
LANGUAGE	ENGLISH
TV/CABLE	CABLE
CH PROGRAM	ENTER
ADD/ERASE	ADD
CH LABELING	ENTER
VIDEO LABEL

MENU BACK EXIT WATCH TV

5.Press ENTER to start channel programming. The TV will automatically cycle through every channel (TV or Cable, depending on which you selected in step 3), and store all active channels in the channel memory.

While the TV is cycling through the channels, the message ÒProgramming NowÑPlease WaitÓ appears.

6.When channel programming is complete, the message ÒCompletedÓ appears.

7.Press Channel y or z to view the programmed channels.

Note:

To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control.

TV/VIDEO	RECALL	POWER
	INFO
1	2		3
4	5		6	Channel
7	8		9
				Numbers
+10		CHRTN
100	0		ENT
U	FAV
				MENU
	DVDMENU			yzx •
	FAV			R
				ENTER
CH		VOL		Channel yz

24