Toshiba 24SL410U, 32SL410U Programming channels automatically, To program channels automatically

Chapter 5: Setting up your TV

Programming channels automatically

Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are programmed automatically, you can manually add or erase individual channels in the channel memory.

Note:

•You must configure the ANT/CABLE input source before programming channels ( page 24).

•The automatic channel programming process will erase channels that were previously programmed into the TV’s memory.

•To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control.

•Programming channels when the ANT/CABLE input is configured for Cable will take substantially longer than when the antenna input is configured for Antenna. This is normal; however, once channel programming is finished, you should not have to repeat the programming process again unless your Cable TV service lineup changes significantly.

To program channels automatically:

1 Configure the antenna input source, if you have not already done so ( page 24).

2 Press and open the Setup menu.

3 Highlight Installation and press .

Setup

Installation

REGZA-LINK Setup

Sleep Timer

PC Settings

Media Player

4 (A new set of Installation menu icons will appear, as shown below.) Open the Terrestrial menu, highlight Channel Program and press to bring

up the Start Scan, and press again to begin channel programming.

Installation

Terrestrial

Input Configuration

Channel Program

Channel Options

Channel Tuning ModeAuto

Time Zone

Signal Meter

ANT/CABLE Antenna

Scanning channels, please wait...

52%

Number of Channels Found - 73

Scanning Digital Channels

Found Channels - 118

Cancel

The TV will automatically cycle through all the antenna channels, and store all active channels in the channel memory. While the TV is cycling through the channels, the message “Scanning channels, please wait...” appears (as shown above).

5 To cancel channel programming, press on the

remote control (or highlight Cancel in the onscreen display and press ).

When channel programming is finished, press or to view the programmed channels.

25