Toshiba 50HP66 Setting up your TV Using the TV’s Features Appendix, To control a DVD player

To control a DVD player:

Program the remote control to recognize the brand of your DVD player (see “Programming the remote control to operate your other devices” below.) The buttons shown at right will then control the DVD player.

Press “DVD” first.

Power

INPUT DISPLAY

Input (TV)

Display

Mute (TV)

Number

buttons

Volume +/- (TV)

DVD

Pic Size (TV)

DVD MENU

▲▼ ▼ ▼

ENTER DVD controls

DVD Skip/Search

/

TOP Menu

DVD Clear

Introduction

Connecting your

CT-885

Programming the remote control to operate your other devices

This remote control is pre-programmed to operate most Toshiba satellite receivers, VCRs, and DVD players. To control a non-Toshiba device (or a Toshiba device that the remote control is not pre-programmed to operate), you must follow the steps below to program your remote control.

1.Refer to the code tables (on pages 20 and 21) to find the corresponding code for your device.

If more than one code is listed, try each one separately until you find the one that works.

2.If you are programming the remote control to operate your:

•Cable TV converter/satellite receiver: Press “CBL/SAT.”

•VCR: Press “VCR.”

•DVD player: Press “DVD.”

3.While holding down DISPLAY, press the Channel Number buttons to enter the three-digit code for your device within 10 seconds. Note: If you do not enter the code within 10 seconds from step 3,

or if you enter the wrong code, this operation is canceled.

4.Point the remote control at the cable TV converter/satellite receiver, VCR or DVD player, and press POWER to test the code.

•If the device responds, you entered the correct code.

•If the device does not respond, repeat steps 1–4 using another code.

5.Press “TV” to control the TV.

For future reference, write down the codes you used:

Cable TV converter/satellite receiver code _____________________

VCR code ______________________________________________

DVD player code _________________________________________

19

INPUT DISPLAY

Display

Channel

Numbers

TV

VCR

DVD

CBL/SAT

CT-885

Notes:

•When shipped from the factory, the remote control is set to operate your TV.

•Each time you replace the batteries, you must reprogram the remote control.

•Some newer VCRs are capable of working on either of two remote codes. These VCRs have a switch labeled “VCR1/VCR2.”

If your VCR has this kind of switch and does not respond to any of the codes for your VCR, set the switch to the other position (VCR1 or VCR2) and reprogram the remote control.

TV

Setting up your TV

Using the TV’s Features

Appendix

3X70701A_En_p18-25 19 9/3/06, 2:18 PM