34 Connecting Your TV

Connecting a digital audio system

Point the TV remote control toward the front of the TV and press
the button for the desired function. The signal passes from the
remote control through the TV to the device via the IR Blaster
cable. For more information, see “IR Blaster Setup” on page 55.
(Sample Illustration) Controlling the device(s) - remote control
The IR pass-through feature does not support all IR controlled
devices. Satisfactory quality may not be attainable with certain
devices.
If you cannot locate the device’s infrared sensor:
1Turn off the device.
2Starting at the device’s lower-left corner, place the end of the
device’s remote control (with the infrared emitter) so it touches
the front of the device. Press the POWER button.
(Do not use the TV’s remote control for this step.)
3If the device turns on, the sensor is located where the remote
control touched the device.
4If the device does not turn on, move the remote control slightly
to the right and press the POWER button again.
5Repeat the previous steps if necessary.
Connecting a digital audio system
The TV’s Digital Audio Out terminal outputs a Dolby® Digital or
2-channel down-mixed PCM (pulse-code modulation) signal for
NOTE