67
Setting up your TV
How to navigate the menu
To tune to channels not stored in memory, use buttons 0–9 and the
DASH button on the remote control.
1Press the MENU button.
2Select SETTINGS, SETUP, Auto Tuning, and then press the
OK button.
A confirmation screen appears.
3Press the OK button to start Auto Tuning or press the EXIT
button to abort.
The TV cycles through the channels and stores all active
channels in memory.
4To view the programmed channels, press the CH Up/Down
arrow buttons.
Manual Tuning
After storing channels in memory, you can manually enter channels
if the channel number is known.
1Press the MENU button.
2Select SETTINGS, SETUP, Manual Tuning, and then press
the OK button.
3Use buttons 0–9 on the remote control to enter the channel
number (for example, 56).
4Press the OK button.
5Press the OK button again to begin Manual Tuning.
The channels found are listed at the bottom of the screen.
Antenna
Auto tuning retains stored channels and stores newly found
channels into memory.
To skip an antenna source channel and remove it from memory, set
the channel to be skipped. See “Skipping channels” on page68.
Option: Description:
ATV Analog channel
DTV Digital channel
Option: Description:
NOTE