Toshiba 43A61 owner manual Using the Remote Control

Using the Remote Control

Programming the remote control for use with a non-Toshiba VCR or a cable TV converter

The TV remote control is preprogrammed to operate Toshiba VCRs and cable TV converters.

To use the remote control to operate a non-Toshiba VCR or cable converter:

1.Refer to the VCR and Cable TV converter code tables on pages 15Ð16 to find the corresponding code for your VCR or converter.

If more than one code is listed, try each one separately until you find the one that works.

2.If you are programming the remote control to operate your:

¥VCR, set the TV/CABLE/VCR switch on the remote control to VCR.

¥Cable converter, set the TV/CABLE/VCR switch on the remote control to CABLE.

3.While holding down RECALL, press the Channel Number buttons (0Ð9) to enter the code for your brand of VCR or converter.

4.Point the remote control at the VCR or converter and press POWER to test the code.

If the VCR or converter responds, you have entered the correct code.

If the VCR or converter does not respond to the remote control, you may have entered the wrong code. Repeat steps 1Ð4 using another code.

5.To control the TV, set the TV/CABLE/VCR switch to TV.

For future reference, write down the codes you used:

VCR code	_____________________
Cable TV converter code	_____________________

	LIGHT RECALL POWER			RECALL
TV				POWER
CABLE	MUTE TV/VIDEO TIMER
VCR				TV/CABLE/
1	2	3		VCR Switch
				Channel yz
4	5	6	CH
				Channel
7	8	9
				Numbers
		CH RTN	VOL
100	0	ENT		Enter
		ADV/
.CAPT	PIP CH		MENU
C
FAV	ENTER		FAV
RESET		ADV/	EXIT

PIP CH

Note:

Every time you replace the batteries, you must reprogram the remote control.

Some newer VCRs are capable of working on either of two remote codes. These VCRs have a switch labeled “VCR1/VCR2.” If your VCR has this kind of switch and does not respond to any of the codes for your VCR brand, set the switch to the other position (VCR1 or VCR2) and reprogram the remote control.

14