Toshiba 350, 452, 453 With the position as shown in the figure, Fix it with a seal, As twisting

Note:

Make sure to hold only the black molded part of the exposure lamp. Do not touch any other part than this black molded part.

1.	Using alcohol, clean the area where
	the seal is to be attached..
2.	Align the black line on the lamp harness

Lamp harness Black line

Hole Punched mark

Lamp harness

Seal

6

with the position as shown in the figure,

and fix it with a seal.

3. Align the bent portion of the lamp

harness with the position as shown in the

figure, and fix it with a seal.

4. After the installation, move carriage-1

towards the left and confirm that there is

no abnormality in the lamp harness, such

as twisting.

(6) Rotate the carriage-1 in the direction shown

in the figure at right, not to touch the mirror.

Then take off the carriage-1.

Fig. 6-716

Lamp harness Seal

Punched mark

Fig. 6-717

Fig. 6-718

Note:

When installing the carriage-1, fix the bracket temporarily at the position (A). Then move it to the direction (B) slowly, push it to the end of frame and fix at this position with the screws. (Refer to 3.7.1 in the Service Handbook.)

(A)

(B)

(A)

Fig. 6-719

e-STUDIO350/352/353/450/452/453	6 - 20 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
SCANNER	07/03